• Currently Active UsersCurrently Active Users

    4 members and 179 guests

    Most users ever online was 888, 05-03-2015 at 03:45 PM.

  • Categories Widget (top-down)

  • Poll Widget

  • torquehound

    There is no available content written by torquehound
  • Recent Forum Posts

    Kirblit

    Skimmer Broke

    Like Carter said, you can try superglue or even 2 part epoxy if you have some laying around. The Weldon 3 may work but I bet the edges are too jagged.the

    Kirblit Today, 03:47 PM Go to last post
    maxthedog2000

    Skimmer Broke

    I would try cyanoacrylate, or other glue like you have listed until you figure something else out.

    Sent from my Pixel 2 XL using Tapatalk

    maxthedog2000 Today, 03:25 PM Go to last post
    FireDawg56

    Skimmer Broke

    The plastic of the skimmer is pretty hard...much harder than plex...I am going to try to reattach using Weldon 3, if it will affect the structure of the

    FireDawg56 Today, 01:58 PM Go to last post
    FireDawg56

    Skimmer Broke

    The collection cup on my SCA-301 broke this morning. The bottom part of the cup that fits in to the skimmer neck sheared off. Does anyone have a broken

    FireDawg56 Today, 01:17 PM Go to last post
    Reefkoi

    Cuc

    I think we might have one left Doyle took one yesterday and Iím not sure if another one is left, i know we have one that a guy dropped off looks thin

    Reefkoi Today, 09:00 AM Go to last post
    Reefkoi

    Where is Everyone?

    Coreefer nailed it on the head like always

    Reefkoi Today, 08:35 AM Go to last post
    FunFishin24

    Rebuilding my reef starting with a 40 gallon Zero Edge

    Do you have an eta for getting water in it & get it all started? Looking good tho.

    FunFishin24 Today, 07:24 AM Go to last post
  • Recent Article Comments Widget

  • Recent Blog Posts