PDA

View Full Version : Replacement Screw for Inland Coral Bandsaw



NightStar
09-24-2014, 06:14 PM
I know quite a few of you have inland saws, so I figured I'd post. A little bit ago I was trying to restring the blade on my bandsaw and nothing would keep it up. Ehren helped me trouble shoot and we found out the screw that keeps the bottom wheel in place on the drive shaft had shifted in some way and had been ground into fine brass powder. I looked, but inland does not sell a replacement part for it, or at least I couldn't find it. Finally narrowed it down, that screw is a 3.5mm diameter machine screw. Mostly just an fyi in case anyone else hits this issue. I have several spares now in case any does ever need it.

static reef
09-24-2014, 06:46 PM
Thank you

sent from FBI van #43

hooked
09-24-2014, 06:49 PM
I have spares too. Had the same problem about 6 months ago.